Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
CGI Impact Windows & Doors in Miami Gardens: What to Know First
We install and service CGI impact windows and doors in Miami Gardens as an independent CGI service provider, with most measured surveys scheduled within two business days and written quotes delivered before any work begins. A typical CGI single-hung or horizontal roller replacement runs between $890 and $1,740 per opening, depending on series and wind-exposure rating. We do not start work until the customer holds a written scope with line-item pricing, because Haven Clause 1 states the measurement and the quote are the same document.
This page is for Miami Gardens homeowners who already own CGI products or are comparing CGI against other impact-rated lines for a retrofit or new installation. If the spec isn’t on the page, it isn’t part of the job. Call (754) 354-6649 to schedule your free measured survey.
How CGI Products Fail - and How We Fix Them
- Sentinel by CGI single-hung sash drift. The sash on early Sentinel series units can drop or tilt in the jamb after repeated cycling, especially in Miami Gardens homes where the afternoon sun heats the vinyl frame and the coastal humidity swells the weatherstrip. We measure the frame squareness to 1/16 inch, then shim or replace the balance shoe rather than replacing the entire sash assembly. This preserves the original impact glazing and keeps the warranty intact.
- Sparta horizontal roller wheel corrosion. The stainless roller wheels in Sparta series sliding units seize when salt-laden air penetrates the axle housing, a pattern we see frequently in Miami Gardens properties east of I-95. We remove the panel, clean the track to bare aluminum, and install OEM-spec replacement wheels with a marine-grade lubricant rated for 3,000+ salt-spray hours. Aftermarket wheels with lower load ratings cost less but fail again in 18 months; we document which we used on your photo record.
- Impact-rated laminated glass delamination at the edge. CGI’s laminated impact glass can show edge separation when the polyvinyl butyral (PVB) interlayer degrades from thermal cycling, particularly on west-facing elevations in Miami Gardens where roof overhangs are shallow. We do not attempt to reseal delaminated impact glass, because the interlayer cannot be field-repaired to Miami-Dade NOA standards. We order a replacement insulated laminated unit from the factory, match the Low-E coating by production lot, and install with a new glazing bead.
- WinGuard vinyl frame corner separation. Heat-welded corners on WinGuard vinyl frames can stress-crack when the home settles or when the rough opening was framed 1/4 inch out of square during original construction. We cut back the damaged corner, splice with a mechanical fastening and two-part vinyl weld, then test the assembly for water intrusion with a calibrated spray rack. Full frame replacement is only quoted when the corner damage has compromised the structural fin or the impact-rated reinforcement chamber.
- Escalade entry door multi-point lock misalignment. The Escalade series multi-point locking system binds when the door slab drops on its hinges or when the composite frame absorbs moisture and swells. We check the hinge screw embedment depth first, because Miami Gardens homes built between 2005 and 2015 often used MDF framing that crushes under the factory screw torque. We reset with longer structural screws into the king stud, then realign the multi-point strikes with a laser plumb rather than eyeballing the gap.
Our CGI Impact Windows & Doors Process

- 1
Measured survey you keep. Sonia Raman or a verified crew member arrives in uniform, license number provided in advance, and records every opening to 1/8 inch with a digital measuring system. You receive the printed survey before we leave.
- 2
Diagnosis with the unit in place. We cycle the product, check the glazing edge, and photograph any delamination, corrosion, or frame distortion. These images become part of your documented photo record.
- 3
Parts decision: OEM or documented equivalent. For CGI products still in production, we quote OEM parts with the factory lead time. For discontinued series, we source quality aftermarket components that meet or exceed the original spec, and we note the manufacturer on your written quote.
- 4
Repair or replacement with no change orders. The written price before any work starts is the final invoice. If we find additional damage during disassembly, we document it, stop work, and present a revised scope before continuing. No surprises.
- 5
Post-installation test and photo record. We operate every moving part, check the lock engagement, and run a water spray test on the sill pan. You receive dated photos of the completed work and the 365-Day Done Right Promise in writing.
Before
AfterWhat CGI Impact Windows & Doors Costs in Miami Gardens
| Scenario | Price Range |
|---|---|
| Sentinel or Sparta sash/balance repair (per opening) | $340 - $620 |
| Horizontal roller wheel and track service (per panel) | $280 - $490 |
| Impact laminated glass replacement, standard size | $780 - $1,340 |
| Full CGI single-hung replacement, installed | $890 - $1,450 |
| Full CGI horizontal roller replacement, installed | $1,050 - $1,740 |
| Escalade entry door multi-point lock realignment | $380 - $650 |
| WinGuard frame corner repair vs. full replacement | $520 - $1,890 |
What moves the price: the wind-exposure rating required for your Miami Gardens zone, the glazing specification (clear vs. Low-E vs. impact/insulated laminated), and whether the original rough opening needs reframing. We also carry PGT, CWS, ES Windows, and ECO Window Systems lines, so if a CGI series has been discontinued and no equivalent serves the opening, we can specify an alternative without sending you to another contractor. Call (754) 354-6649 for your free measured survey and written quote.
Why Miami Gardens Homeowners Call Sightline Windows & Doors Miami Gardens for CGI Work

We are independently owned and operated under the Haven Standard, not a franchise or a manufacturer-authorized dealer. That means we specify CGI when the opening calls for it, and we specify PGT, CWS, ES Windows, or ECO Window Systems when those lines better match the performance tier or budget. Every technician is background-checked, uniformed, and identified by license number before arrival, per Haven Clause 3. The 365-Day Done Right Promise covers every job, and the documented photo record is standard, not an upsell.
Sonia Raman grew up in Miami proper, where watching older homes get retrofitted after every hurricane season made windows and doors feel less like a renovation category and more like a civic responsibility. She still quotes exact U-factor and SHGC values on every estimate rather than selling people on a brand name. In Miami Gardens, she and her crew have worked steadily near St. Thomas University, where wind-exposure ratings and insurance documentation come up in almost every conversation. The small level her father gave her stays in the truck, even with three calibrated digital ones on hand.
FAQs
No, provided the repair uses OEM-spec parts and does not alter the original frame or glazing package. We document every part source on your written scope so the warranty trail is clear. If the warranty has already expired, we explain which aftermarket parts we are using and why. Call (754) 354-6649 to schedule a free inspection and written assessment.
In-stock CGI components arrive in 5 to 10 business days; factory-ordered laminated glass units or discontinued-series parts can take 3 to 5 weeks. We quote the lead time on the written scope before you commit, and we do not collect deposit until you approve the timeline. Call (754) 354-6649 for current availability on your specific series.
Repair is viable when the frame is square, the glazing is intact, and the failure is isolated to hardware or weatherstrip. We recommend full replacement when the frame has corner separation, the laminated glass is delaminated, or the series is discontinued and parts are no longer factory-supported. Your written quote will state both options if both are technically sound. Call (754) 354-6649 for a measured survey and honest comparison.
Yes, if the series is still in production. We match by frame color, grid pattern, and hardware finish using CGI’s production records. For discontinued lines, we identify the closest current-series equivalent and show you the sample before ordering. The photo record includes the existing unit and the replacement for your insurance file. Call (754) 354-6649 to schedule.
The written price before any work starts, the verified crew with license numbers on record, and the documented photo evidence on every job. We do not operate from a template or a commission structure; we specify by opening, by performance requirement, and by what the measured survey shows. The 365-Day Done Right Promise is stamped on every job, not offered as a courtesy. Call (754) 354-6649 to schedule your free measured survey.
Written by Sonia Raman, Owner, Sightline Windows & Doors Miami Gardens at Sightline Windows & Doors Miami Gardens, serving Miami Gardens and nearby areas.










Before
After
Before
After
Before
After